Wooden mounting rail / cleat for hanging things

StatusPlanned
CategoryDoor
Wooden mounting rail / cleat for hanging things
  • What: A wooden bar/cleat mounted to the DOOR (ribbed steel. see photo) to screw hooks/accessories into, so hung items stop slipping off the bare rib lip. No factory threaded holes on the door → can't bolt to captive nuts here.
  • How the Transit community mounts wood to a door with no factory holes. two standard ways:
  • A) 3M VHB adhesive. no drilling (recommended for light hook loads). Bond the cleat with a perimeter of ¼" 3M VHB tape; prime the raw wood first (contact cement or 3M 90 spray) so it actually sticks. Zero holes → nothing on the exterior, no rust. Popular exactly because it avoids drilling the door.
  • B) Rivnuts into the door's INNER STRUCTURAL frame. stronger, removable. Drill fresh holes in the inner structural rib (NOT the thin outer skin), set M6 / ¼-20 rivnuts, bolt the cleat on. Handles heavier loads; needs a rivnut tool. ⚠️ Rivnuts in bare sheet-metal pull out under load. go into the structural frame.
  • (Off-the-shelf: Flatline Van Co. makes Transit rear-door panels/platforms if I'd rather buy a kit.)
  • ⚠️ Door cautions: never drill the outer skin (shows outside + rusts) or into wiring / latch rods / window motor behind the panel. check depth + what's behind first. The door slams, so the mount must take vibration (full VHB perimeter, or ≥2 rivnuts).
  • The rail: ¾" ply / hardwood strip, sealed/painted; screw hooks / a hook rail into the wood face.
  • Need to buy: hardwood/ply strip; 3M VHB tape (¼") + primer (contact cement / 3M 90 spray) (Option A). OR rivnut tool + M6/¼-20 rivnuts + bolts (Option B); hooks/hardware; sealant/paint
  • Tools: drill ✅, oscillating saw ✅, rivnut tool (only for Option B)
  • Measure/decide: VHB vs rivnuts (load + do you want ZERO holes?); rail length; flat bonding area (for VHB) or inner-rib locations + what's behind the skin (for rivnuts)

Photos

Wooden mounting rail / cleat for hanging things

← All Build Journal