MAXTRAX recovery boards (roof mount)

StatusPlanned
CategoryRoof
  • What: Move the MAXTRAX boards from the interior mount up to the roof. Plan the roof layout together with P4 (Starlink). both share the roof.
  • Base: 8020 crossbars on the roof (same profile as the build). or clamp to an existing roof rack / factory rails. Avoid new roof penetrations where possible (clamp to rails/track); any bolt through the roof gets butyl + Sikaflex sealed (same as the Starlink mount).
  • Board attach (reuse the P13 anti-bounce design, now on the roof): studs (SS threaded rod or MAXTRAX mounting pins) through the boards' molded holes into the crossbars, with standoff spacers (kill bounce) + locking pins (theft. roof is exposed) + anti-rattle washers.
  • Roof-specific watch-outs: wind lift (must be tight, no flap); theft (locking pins); added height/clearance (note garage + overhead clearance with boards up top); weight up high; access to load/unload.
  • Have: MAXTRAX boards ✅, T-nuts ✅
  • Need to buy: roof 8020 crossbars + feet/clamps (if no roof rack); MAXTRAX roof mounting/locking pins or SS rod + standoff spacers + knobs; roof sealant (butyl/Sikaflex) if penetrating; hardware
  • Tools: drill ✅, hacksaw/cutoff for rod
  • Measure/decide: roof space L×W for the boards + coordinate footprint with Starlink (P4) so both fit; existing roof rack/8020 profile or add crossbars; board stack dims (hole spacing + stack height, from P13); overhead/garage clearance with boards on top; clamp-to-rails vs penetrate

← All Build Journal