MAXTRAX (MXP) recovery-board mount (rebuild)

StatusPlanned
CategoryStorage
  • ⚠️ Superseded by P18 (moving the boards to the roof). Keep as a fallback if the roof mount doesn't pan out; the anti-bounce design below is reused by P18.
  • What: Current 80/20 mount for the MAXTRAX boards isn't stable. it bounces/rattles. Rebuild it stiff, with easy tool-free lock/unlock. (A board working loose while driving is a safety issue. worth doing right.)
  • Design (standoff-stud):
  • Studs: stainless threaded rod (or MAXTRAX pins) anchored into the 80/20 via stud T-nuts / drop-in T-nuts, projecting through the boards' molded holes.
  • Spacers (the anti-bounce part): aluminum or stainless standoff spacers sized to boss depth + stack height. they take the clamp load so the board is captured solid, not crushed or loose.
  • Lock/unlock: star-knob / hand knobs (tool-free) OR a quick-release ball-detent pin through a cross-drilled stud. Consider MAXTRAX locking pins (theft. boards are exposed).
  • Anti-rattle: rubber/neoprene washer between board + spacer.
  • Two paths: fully custom (SS rod + spacers + knobs = sturdier/cheaper) OR MAXTRAX official mounting pins + locking pins (faster, off-the-shelf).
  • Have: MAXTRAX boards ✅, existing 80/20 mount ✅
  • Need to buy: stainless threaded rod (cut to length) or MAXTRAX mounting/locking pins; aluminum/SS standoff spacers; star knobs or quick-release/locking pins; stud/drop-in T-nuts (match profile); rubber/neoprene anti-rattle washers
  • Tools: drill ✅, hacksaw/cutoff for rod
  • Measure: 80/20 profile; board hole spacing (c-to-c) + hole dia; # boards stacked + board/boss thickness → stack height → rod + spacer length; standoff distance + clearance behind

← All Build Journal