Front light bar (on 8020) + exterior wire entry
StatusPlanned
CategoryExterior
- What: Mount an off-road LED light bar on the front 8020 (front crossbar) + add a new weatherproof exterior wire entry to power it. (Distinct from P11, the interior overhead bar.)
- Mount: clamp/bracket the light bar to the front 8020 crossbar (match profile, use T-nuts).
- Wire entry (the ask): run power to the exterior through a weatherproof roof cable gland near the front. same type as the Starlink gland (P4); a separate entry positioned near the bar. Seal butyl/Sikaflex. (If mounted lower/grille-level instead → firewall grommet.) Coordinate placement with P4/P18 roof work.
- Electrical. use a relay (light bars pull real current): relay + fused harness. low-current switch in the cab triggers the relay; main power from the battery via an inline fuse. Most light bars ship with this harness (relay + fuse + switch). confirm yours does. Switch trigger ties into P8 wiring; main feed fused at the battery/busbar.
- Weatherproofing: heat-shrink/sealed exterior connections; drip loop at the gland.
- ⚠️ Legal: forward-facing light bars generally aren't street-legal on public roads (many states require a cover / on-road lockout). Fine off-road/at camp. wire the switch accordingly.
- Need to buy: LED light bar; 8020 mounting brackets/clamps (match profile); light-bar wiring harness (relay + fuse + switch) if not included; exterior cable entry gland (roof gland box / or firewall grommet); butyl/Sikaflex; heat-shrink/weatherproof connectors
- Tools: drill ✅
- Measure/decide: where on the front 8020 + bar size/length; wire-entry location (front roof gland vs firewall). coordinate with P4/P18 roof layout; inside wire-run length; confirm 8020 profile; does the bar include a relay harness?